Autorobot Finland Oy» Back
Support and jig sets
519C Support set
Support set No. 519C helps focus the straightening force so that only the damaged area is affected, speeding up the straightening process.
The support/pull combination makes small damage straightening possible without fastening the vehicle onto a bench. It only needs to be lifted from the bench ramps with the lifting arm set (No. 720) and the quick-lock fastening side support placed on the other side of the vehicle.
676B-2A+ Two Point Bearer Set
676B-2A+ Two Point Bearer Set can be used to support vehicle structures during frame straightening. A correctly focused hold helps to work only the right area and prevents the pulling force from effecting the undamaged parts. This is especially important for example with new, strong body structures. With the 676B-2A+ set the frame end parts can be adjusted in the right position (length, width and height) before welding them to the vehicle frame. The measuring system gives the correct coordinates for the parts to be welded.
680E Adjustable bearer for support and straightening
When straightening upwards or downwards, No. 680E adjustable bearer can be used both for support and actual straightening. As in drawings 5 and 6, bearer screw A provides the push/pull power of approximately 4 tons, which is often enough for aligning vehicle front or rear structures. The bearers can be installed for support as well along extensions No. 550XLD by using brackets D.