Autorobot Finland Oy

» Back

Support and jig sets

519C Support set

Support set No. 519C helps focus the straightening force so that only the damaged area is affected, speeding up the straightening process.

The support/pull combination makes small damage straightening possible without fastening the vehicle onto a bench. It only needs to be lifted from the bench ramps with the lifting arm set (No. 720) and the quick-lock fastening side support placed on the other side of the vehicle.

Support and jig sets - Vehicle fastening and support - Autorobot Support and jig sets - Vehicle fastening and support - Autorobot Support and jig sets - Vehicle fastening and support - Autorobot Support and jig sets - Vehicle fastening and support - Autorobot Support and jig sets - Vehicle fastening and support - Autorobot

676B-2A+ Two Point Bearer Set

Support and jig sets - Vehicle fastening and support - Autorobot

676B-2A+ Two Point Bearer Set can be used to support vehicle structures during frame straightening. A correctly focused hold helps to work only the right area and prevents the pulling force from effecting the undamaged parts. This is especially important for example with new, strong body structures. With the 676B-2A+ set the frame end parts can be adjusted in the right position (length, width and height) before welding them to the vehicle frame. The measuring system gives the correct coordinates for the parts to be welded.

Support and jig sets - Vehicle fastening and support - Autorobot Support and jig sets - Vehicle fastening and support - Autorobot

Support and jig sets - Vehicle fastening and support - Autorobot Support and jig sets - Vehicle fastening and support - Autorobot

676B-2A+ holds still the undamaged areas while other parts of the vehicle are being pulled.

Support and jig sets - Vehicle fastening and support - Autorobot Support and jig sets - Vehicle fastening and support - Autorobot
Support and jig sets - Vehicle fastening and support - Autorobot

676B-2A- Two-point bearer and straightening set

680E Adjustable bearer for support and straightening

When straightening upwards or downwards, No. 680E adjustable bearer can be used both for support and actual straightening. As in drawings 5 and 6, bearer screw A provides the push/pull power of approximately 4 tons, which is often enough for aligning vehicle front or rear structures. The bearers can be installed for support as well along extensions No. 550XLD by using brackets D.

Support and jig sets - Vehicle fastening and support - Autorobot Support and jig sets - Vehicle fastening and support - Autorobot Support and jig sets - Vehicle fastening and support - Autorobot

B15-1A Extension beam with wedge, metal (6,3mm thick)

Support and jig sets - Vehicle fastening and support - Autorobot